1970 C30 Car hauler Buildish thread.

[jarrodblake]

Not much of an update I have been super busy with work and other small project and a little renovation.

I started tearing into the cab. removed the outer rocker.

[IMG]IMAG0892 by jarrod vanwinkle, on Flickr[/IMG]

Then I drilled out the rear of the floor to cab spot welds.

[IMG]IMAG0895 by jarrod vanwinkle, on Flickr[/IMG]

Then I cut out the old rear floor section and support.

[IMG]IMAG0893 by jarrod vanwinkle, on Flickr[/IMG]
[IMG]IMAG0911 by jarrod vanwinkle, on Flickr[/IMG]

I did a quick test fit

[IMG]IMAG0912 by jarrod vanwinkle, on Flickr[/IMG]

Looks like I will have to make a center floor section

[IMG]IMAG0894 by jarrod vanwinkle, on Flickr[/IMG]

So I decided to drill out the rest of the spot welds the mount the rear of the floor to the cab. I before I drilled them out I made some bracing.

[IMG]IMAG0897 by jarrod vanwinkle, on Flickr[/IMG]

So my current doors are shot so I picked up a set on CL That I thought were in good condition. But they had been poorly repaired. They replaced the outer lower skin and lap welded it together so I get to re do that and I may also replace the inner lower as well as it has a few small holes and speaker cut outs.

[IMG]IMAG0898 by jarrod vanwinkle, on Flickr[/IMG]

I also picked up a new fender that had been damaged right after it was installed its an easy fix my fender has a lot of bondo and rust.

[IMG]IMAG0899 by jarrod vanwinkle, on Flickr[/IMG]

I did a quick test fit of the door and fender

[IMG]IMAG0909 by jarrod vanwinkle, on Flickr[/IMG]
[IMG]IMAG0910 by jarrod vanwinkle, on Flickr[/IMG]

Also does anyone know what axle this is?

[IMG]IMAG0904 by jarrod vanwinkle, on Flickr[/IMG]
[IMG]IMAG0905 by jarrod vanwinkle, on Flickr[/IMG]