No Limit Square Body 4-Bar

[808_67C10]

Originally Posted by robnolimit

**ALWAYS USE A TAPE MEASURE **** lol. Sure, the notch looks a little small. BUT, at some point, the axle hitting the frame is not the problem, the top of the third member will smack the bed floor. So, since this kit was developed for stock bed floor trucks, there was no reason to notch farther than that. It does make me wonder if other manufacturers actually planned this out, or just cut half the frame and called it a day.

Good point. I often wondered the same with C-notches. Also, I would be curious to see what happens if a truck with a bolt in (or even a weld in) C-notch gets rear ended. Your looks like it would be much stronger in that unlikely event. Killer looking product, as always!!!