|
04-28-2004, 01:03 AM
|
#1 |
|
PROJECT 7DEUCE
 
Join Date: Dec 2002
Location: GRANTS PASS OR
Posts: 21,606
|
Need opinion
I was wondering what to do about the door I screwed up while welding on it I got it too hot and now it's bowed in a spot where the door handle use to be .... Should I cut it back out and weld in a new patch pannel or hammer and dolly the area till it's smooth any idea's or opinion's would be great here's a crappy pic's but it show's the damage...
__________________
GO BIG GREEN  GO DUCKSMEMBER #6377 72 k-5 daily driver 6'' lift 35'' 350-350-205 slowly getting rust free. Project "7DEUCE" check out my build http://67-72chevytrucks.com/vboard/s...d.php?t=267665 Tim Powell..R.I.P EastSideLowlife..... R.I.P.. |
|
|
|
04-28-2004, 01:22 AM
|
#2 |
|
Member since 2000
Join Date: Dec 2000
Location: Mountain View Ca / Mexico
Posts: 7,874
|
I'd hammer away for a while. If that doesn't work then cut it out and take your time welding. if you mess up agian.......they always did say the 3rd time the charm
Last edited by Alexis; 04-28-2004 at 01:36 AM. |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
