|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
05-07-2004, 10:06 PM
|
#1 |
|
Registered User
 
Join Date: Sep 2003
Location: Wichita, KS
Posts: 3,735
|
Bed Disassembly question
I have my '72 bed off the frame and am now trying to completely disassemble it. I have every single bolt off and now am stuck trying to cut through the spot welds at the rear of the bed. I have a grinder but can't get the right angle with it. I also have tried a hacksaw and drill but they take tooooo long. I have thought about using a cutting torch, but I am afraid of over doing it. Any suggestions would be greatly appreciated....Thanks...John
|
|
|
|
05-07-2004, 10:10 PM
|
#2 |
|
Account Suspended
Join Date: Apr 2004
Location: N.C. high country
Posts: 6,107
|
Do you have an air compressor ? i used an air chisel to get mine off.
|
|
|
|
|
05-07-2004, 10:51 PM
|
#3 |
|
Registered User
Join Date: Jul 2003
Location: north of Phx AZ about 30 miles
Posts: 698
|
I used a die grinder with mine, then finished it off with a hack saw. Don't forget the bolts right under where the welds are.
__________________
Andy,Phx AZ '67 C-10 (Ahhh, done at last. Well there is that disk front end I want to put in and...) "23 C-Cab-sold '48 Ford 8N tractor(still working) '67 Scout(Now on the road) '70 MG B.-sold |
|
|
|
|
05-07-2004, 10:56 PM
|
#4 |
|
PROJECT 7DEUCE
Join Date: Dec 2002
Location: GRANTS PASS OR
Posts: 21,606
|
Die grinder work's great so will a hand drill with a cut off wheel attached to it...
__________________
GO BIG GREEN  GO DUCKSMEMBER #6377 72 k-5 daily driver 6'' lift 35'' 350-350-205 slowly getting rust free. Project "7DEUCE" check out my build http://67-72chevytrucks.com/vboard/s...d.php?t=267665 Tim Powell..R.I.P EastSideLowlife..... R.I.P.. |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
