|
07-08-2018, 07:25 PM
|
#1 |
|
Senior Member
 
Join Date: Jun 2000
Location: Texan in Iowa
Posts: 2,522
|
Spindle diameter
My '68 C10 spindles have some wear on the bottom where they rest on/in the inside bearing race. The shaft was originally 1.375" and now is 1.372". In the past I've had a vehicle that had this kind of wear and it prevented me from achieving a good alignment. So, just replace them, right? But I can't find any new ones--I don't think they exist. Do used, unworn sets still exist?
I'm looking for your input on whether this is enough wear to cause an issue on these pickups. Or if you have any solutions, let me know. (Yes, I want to keep the front drums.  )
__________________
Ben '68 Chevy C10 Custom LWB 327/TH400 2nd owner '16 GMC Sierra 1500 SLE Dblcab 4wd 5.3 |
|
|
|
07-09-2018, 09:36 AM
|
#2 |
|
Registered User
Join Date: Apr 2015
Location: New Sharon iowa
Posts: 75
|
Re: Spindle diameter
what part of iowa? I know of a scrape yard in se iowa that have tons 67-72 trucks.
|
|
|
|
|
07-09-2018, 09:38 PM
|
#3 |
|
Senior Member
Join Date: Jun 2000
Location: Texan in Iowa
Posts: 2,522
|
Re: Spindle diameter
Hey I’m in Des Moines. What town is the yard in?
__________________
Ben '68 Chevy C10 Custom LWB 327/TH400 2nd owner '16 GMC Sierra 1500 SLE Dblcab 4wd 5.3 |
|
|
|
|
07-09-2018, 09:39 PM
|
#4 |
|
Registered User
Join Date: Apr 2015
Location: New Sharon iowa
Posts: 75
|
Re: Spindle diameter
Eddyville. The place is called Witts
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
