![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Jun 2010
Location: Orlando, Florida
Posts: 2,508
|
AC Ball housing cut out to use as template to cut dash
I am putting AC in my truck when it goes back together, so I cut the vent holes in the dash. The center vent is relatively easy, but the side ones are tricky. I got a template from a member, which helped, but I was concerned about cutting the hole wrong. I decided to sacrifice a pair of vent ball housings for the job. I cut them so they lay flush against the dash, and then traced the outline of the holes on the inside. It worked pretty well, but I had to do some trimming and fitting.
I am done with these, but I think someone here could use them to do theirs. $20 shipped, CONUS. First "I'll take it" gets them.
__________________
71 Chevy C10 Shortbed Stepside. LT1 with 4l60E. Just got back from painter, in assembly now. |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Jun 2010
Location: Orlando, Florida
Posts: 2,508
|
Re: AC Ball housing cut out to use as temple to cut dash
One more pic
__________________
71 Chevy C10 Shortbed Stepside. LT1 with 4l60E. Just got back from painter, in assembly now. |
![]() |
![]() |
![]() |
#3 |
GM Addicted
Join Date: Jan 2009
Location: Visalia, Ca
Posts: 2,291
|
Re: AC Ball housing cut out to use as template to cut dash
I’ll take em
__________________
![]() ![]() 73 GMC, 54 Caddy, 2010 Silverado, 68 C10 RIP DAd My 73 GMC Truck Build Pic 2010 Silverado 4/6 on 24s IG:MacsGarage |
![]() |
![]() |
![]() |
#4 |
Registered User
Join Date: Jun 2010
Location: Orlando, Florida
Posts: 2,508
|
Re: AC Ball housing cut out to use as template to cut dash
PM sent
__________________
71 Chevy C10 Shortbed Stepside. LT1 with 4l60E. Just got back from painter, in assembly now. |
![]() |
![]() |
![]() |
#5 |
GM Addicted
Join Date: Jan 2009
Location: Visalia, Ca
Posts: 2,291
|
Re: AC Ball housing cut out to use as template to cut dash
PayPal sent thanks. Was just thinking of finding some to use as templates. Have a few vintage air installs coming up that want to install factory vents.
__________________
![]() ![]() 73 GMC, 54 Caddy, 2010 Silverado, 68 C10 RIP DAd My 73 GMC Truck Build Pic 2010 Silverado 4/6 on 24s IG:MacsGarage |
![]() |
![]() |
![]() |
Bookmarks |
|
|