|
05-14-2004, 01:39 PM
|
#1 |
|
Registered User
Join Date: Mar 2004
Posts: 65
|
key swap
hi all,
I just got a new set of lock and ignition keys for the truck. Any info out there about how to swap the ignition tumbler? I can't find the old key, either, am I screwed? should I just call the locksmith? jason |
|
|
|
05-14-2004, 02:56 PM
|
#2 |
|
Registered User
Join Date: Jan 2004
Location: glendale/tucson
Posts: 199
|
you have to take the wheel off and someother stuff inside the column out and then there is i cant remember 1 or 2 screws holding the tumbler in.
|
|
|
|
|
05-14-2004, 08:13 PM
|
#3 |
|
Registered User
Join Date: May 2004
Location: Minnesota
Posts: 4,621
|
Check out this web site
http://home.t-online.de/home/O_Scholz/steering.html It shows a tilt column. A non-tilt column is little easier, but not much different if your just changing the ignition cylinder. The first time you remove the clip that holds down the lock plate, you might cuss a bit. Good luck |
|
|
|
|
05-15-2004, 01:34 AM
|
#4 |
|
Registered User
Join Date: Mar 2004
Posts: 65
|
awesome, thanks!
|
|
|
|
|
05-15-2004, 07:17 AM
|
#5 | |
|
Registered User
Join Date: Jan 2003
Location: Washington State
Posts: 8,834
|
Quote:
Still have the tool for depressing the locking plate to get that first snap ring off.
__________________
1970 Chev CST 2003 Harley Fatboy 1975 Chevrolet Step Van 1956 Chev Bel Air 1977 Blazer 2WD For Sale $3000.00 1978 Blazer 2WD For Sale $7000.00 1978 Silverado 2005 Monte Carlo |
|
|
|
|
|
05-15-2004, 02:53 PM
|
#6 |
|
Registered User
Join Date: Mar 2004
Posts: 65
|
yeah, just rented that.
j |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
