|
05-15-2004, 03:37 PM
|
#1 |
|
blood type; Retumbo
Join Date: Jan 2004
Location: next to my reloading bench
Posts: 10,269
|
widening x-member
not long ago I asked about installing a '78 G body front frame in my '68. I was told the G body track width is 7" narrower than our trucks.
 since then I have been thinking. what if a person was to cut it down the middle & widen it about 5". ( I am thinking that 2" would be good for room to turn wheels inside fenders.) granted I would need to make the center liks longer, no problem. has anyone else had this thought or tried it before? any engineers here that can help? (Jewels?) I really want the geometry & ride quality. I know there are places like Fatman & Heidts that have real nice kits, but I am kind of old school & like to fab. for myself.  
__________________
Man rule #77...if you own a 67 stepside with a caddy 472 you will never be in danger of loosing you man card |
|
|
|
05-16-2004, 03:51 PM
|
#2 |
|
blood type; Retumbo
Join Date: Jan 2004
Location: next to my reloading bench
Posts: 10,269
|
23 views & no replies, am I alone on this concept? need feedback please
thanks-Todd
__________________
Man rule #77...if you own a 67 stepside with a caddy 472 you will never be in danger of loosing you man card |
|
|
|
|
05-16-2004, 08:01 PM
|
#3 |
|
Fabricate till you "puke"
Join Date: Jun 2002
Location: Ill
Posts: 9,403
|
Well, im no engineer, but from a backyard mech/fab guys point of veiw, i would probably think about playing with wheel offset.If you run 10" wide wheels, you canprobably make up 2 1/2- 3" per side. Or just go for the stub that would be about the proper width(camaro?). This mod is not something i have tryed......so i dont have too much advice. Best of luck,crazyL
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears.... |
|
|
|
|
05-16-2004, 08:09 PM
|
#4 |
|
just can't cover up my redneck
Join Date: May 2004
Location: Columbus OH
Posts: 11,414
|
It would probably be tricky. You will lose your motor mount area, so you would have to fab something for that too. You have to come up with something to steer with. Oilpan clearance, ground clearance....
Lots of factors, I'm not saying it can't be done, just that it will take a lot of work. |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
