|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
03-17-2019, 10:41 AM
|
#7 |
|
Registered User
Join Date: Jul 2016
Location: Brandon,MS
Posts: 489
|
Re: 4.8 to th350 troubleshooting
I used the dished flex plate not the flat one that was with my old engine. So I did not need a spacer. I also used the ring to center the engine and trans. The flex plate holes will not line up but that is a easy fix. I simply reamed out the hole about a 1/4 inch.
|
|
|
| Bookmarks |
|
|
Threaded Mode