|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
04-08-2019, 11:31 AM
|
#17 |
|
Registered User
Join Date: Nov 2006
Location: Sutherlin Oregon
Posts: 509
|
Re: Reproduction bed vs Original bed.
That pic was from parts I got last summer. I should have taken more pic's but didn't think to until I had already started work. The stake pockets were the worst, and where they attached to the bed side. Put straight edge on inside of bed at each end and it was cupped in and wavy. Needed a lot of work each end to about 12" in, inside and out, and the entire top from the angle to the tube.
|
|
|
| Bookmarks |
|
|
Threaded Mode