|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-17-2019, 03:52 PM
|
#1 |
|
Registered User
 
Join Date: Jul 2012
Location: Burleson Texas
Posts: 570
|
Header question on manual trans swap
Anyone have experience with a mid length header in a 71 C10 when doing a 5.3 and TKO-600 swap with a 621 bell ? Not sure if clearance was any different than with an auto like a 60 or 80
__________________
My 71 build thread http://67-72chevytrucks.com/vboard/s...d.php?t=548438 |
|
|
|
04-17-2019, 04:09 PM
|
#2 |
|
Registered User
Join Date: Jul 2014
Location: North-central Virginia
Posts: 1,099
|
Re: Header question on manual trans swap
External slave, Internal slave, or Z-bar linkage?
|
|
|
|
|
04-17-2019, 04:44 PM
|
#3 |
|
Registered User
Join Date: Jul 2012
Location: Burleson Texas
Posts: 570
|
Re: Header question on manual trans swap
Its what I would call an internal hydraulic slave. Has the hydraulic bearing behind the press plate and a small hydraulic line coming out of rectangular hole in bellhousing up to clutch master cyl on firewall. There is some slack in the hose
__________________
My 71 build thread http://67-72chevytrucks.com/vboard/s...d.php?t=548438 |
|
|
|
|
04-17-2019, 05:33 PM
|
#4 |
|
Registered User
Join Date: Jul 2014
Location: North-central Virginia
Posts: 1,099
|
Re: Header question on manual trans swap
With an internal slave, I can't see how clearance would be any different than with an automatic. But I have no experience, though.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
