1947 Panel Truck Frame swap with ’88 k2500

[Second Series]

Thanks for the feedback. I'm not too concerned with the wheels sticking out of the wheel wells, just addressing the issue beforehand. I'm kind of dragging my feet at this point, waiting until fall to start. I'm going through the different systems, planning how each will work. I'll use the stock gauges, so a bit of design work there. I figured out how to keep the stock ignition switch and foot starter. I'll look at everything else on the wiring diagram, I'd like to eliminate the bulkhead connector if I can. I'll look into building a drive for the speedometer too.