CA 1964 c10 292 clutch linkage

[Mike_The_Grad]

I am looking for new clutch linkage components. Z-bar, ball studs(engine side, frame side, bellhousing.) I have the rods already, need the swivel though. Plus clips/retainers, felt washers. I have the fork already too.
Any help with all or part or even just pointed to the right source for this stuff would be greatly appreciated.

[SmirchIs#1]

Originally Posted by Mike_The_Grad

I am looking for new clutch linkage components. Z-bar, ball studs(engine side, frame side, bellhousing.) I have the rods already, need the swivel though. Plus clips/retainers, felt washers. I have the fork already too.
Any help with all or part or even just pointed to the right source for this stuff would be greatly appreciated.

I have a friend that just converted a 69' 292cu.in. 4X4 truck to a 350.I'll bet at least some of the parts could be the same?No?

[Mike_The_Grad]

I ended up going through a vendor for the parts I needed. Turns out I needed less than I thought. Thanks for the reply though.