|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
07-29-2019, 07:25 AM
|
#1 |
|
Senior Member
 
Join Date: Mar 2012
Location: Chesapeake, Va
Posts: 1,275
|
Re: Heater Cable Removal Tip
well I removed mine yesterday as i was tearing down the cab for paint, and i snapped a couple of the retainers in half.
Where can i find some decent replacement retainers?? I realize this is an older post but you never know...
__________________
Mike 72 C-10 Cheyenne off frame resto and Upgraded to 4 wheel disk, Tilt, Dakota Digital Dash / Rear slider. 421 SBC / TH350 3000RPM Stall Progression Ignition /Holley 750 DP/3:73 gear Eaton Limited Slip unit / 2 1/2 exhaust glasspacks 
|
|
|
|
07-29-2019, 07:47 AM
|
#2 |
|
Registered User
Join Date: Dec 1999
Location: Marysville, Michigan, USA
Posts: 222
|
Re: Heater Cable Removal Tip
I was just at Ace Hardware over the weekend looking for something similar (a thin thread on nut). I'd check your local hardware store in the nut & bolt section. Ours had several automotive trays which included some of these push on clips.
__________________
67 GMC C2500 GMC V6 4spd NP435 Dana 60 4.10 Power Lok |
|
|
|
|
| Bookmarks |
|
|
Hybrid Mode
