1958 SWB C4 Fleetside - NZ Build - The 1947 - Present Chevrolet & GMC Truck Message Board Network

QBRacing · 01-21-2020, 04:04 AM

Just a couple of pics to show the steering intermediate finally fitted.

Didn't take much really, just a piece of 3mm galv plate, extend the 90 degree bend (with use f a hammer and vice) , then I drilled a couple of holes in the plate and the bracket for the C4 Corvette Suspension chassis boxing and presto ..... the steering column is complete

The top bearing is a bit graunchy so I might pull it apart and replace it (are all late model chevy car/truck columns the same (bearings held in a piece of plastic)

Pic 1 - looking down
Pic 2 - looking up

01-21-2020, 04:04 AM	#10
QBRacing Registered User Join Date: Apr 2016 Location: Auckland, NZ Posts: 300	Re: 1958 SWB C4 Fleetside - NZ Build Just a couple of pics to show the steering intermediate finally fitted. Didn't take much really, just a piece of 3mm galv plate, extend the 90 degree bend (with use f a hammer and vice) , then I drilled a couple of holes in the plate and the bracket for the C4 Corvette Suspension chassis boxing and presto ..... the steering column is complete The top bearing is a bit graunchy so I might pull it apart and replace it (are all late model chevy car/truck columns the same (bearings held in a piece of plastic) Pic 1 - looking down Pic 2 - looking up Attached Images __________________ My 1958 SWB Fleetside Build My 1971 Nova Build Site



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.