|
06-17-2004, 07:19 PM
|
#1 |
|
Registered User
 Join Date: Sep 2002
Location: Northwest,Indiana
Posts: 128
|
Header Advice Please
I have bought a set of dynomax headers and I noticed the tubes look dangerously close to the plugs ie: burnt wires look to be in my future. I have always run manifolds on all of my toys until this project for some reason ,so I dont have alot of experience with headers. Is it the headers meaning did I buy a cheap set or is this common for these trucks and if so what are some solutions like high temp wires header wrap etc. What have you guys experienced?
__________________
67' Chevy C10 Lwb small rear window 71' Gmc 1500 custom 4x4 72' Gmc Grande Sierra |
|
|
|
06-17-2004, 07:31 PM
|
#2 |
|
Registered User
Join Date: Jun 2003
Location: Linden, North Carolina
Posts: 617
|
Use shorty plugs and you can gain some clearance. I am going to install plug wire insulators from Summit beacuse I just burnt through another wire(read expensive) and I am using shorty plugs already.
__________________
64 Panel Rebuild Pics Clutch Replacement and Borg Warner T10 Trans Rebuild 64 Panel 1/2 Ton 350cubes/400hp BorgWarner t-10 3:73 Auburn Posi |
|
|
|
|
06-17-2004, 07:40 PM
|
#3 |
|
Fabricate till you "puke"
Join Date: Jun 2002
Location: Ill
Posts: 9,402
|
Yup, high temp wires & shorty plugs! i cant say from experience on the dynomax headers, but I have run Hedman, & Hooker with very little problems.....once in a while, I do have a plug boot split from the heat(what the he!! , its a hotrod!). Some of the best wires I have run are MSD spiral core. They seem to hold up to the heat pretty well. crazyL
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears.... |
|
|
|
|
06-17-2004, 08:05 PM
|
#4 |
|
Senior Member
Join Date: Jan 2003
Location: daytonabeach
Posts: 22,956
|
ceramic-coated headers fry less wires because they'll run cooler
__________________
71c-10 350/2004r/4:11 lowered3/4 longbed/dead by hurricane MEANING OF DEATH::::: SOMEBODY ELSE GETS YOUR STUFF DONT BELIEVE EVERYTHING YOU THINK TAKE MY ADVISE;I DON'T USE IT ANYWAY |
|
|
|
|
06-17-2004, 09:08 PM
|
#5 |
|
Senior Member
Join Date: Apr 2000
Location: Delta,Pa
Posts: 14,948
|
im running dynomax headers and yes they are tight and look like they wont fit but i run autolite 25 plugs and taylor wires havent burnt one yet
__________________
Owner of North Point Car Care in Dundalk Md. We specialize in custom exhaust on both modern and classic vehicles. We are a full service auto shop from classics to modern vehicles. Feel free to contact me with questions. I will give a 10% discount to any board member. |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
