Dana Spicer 3153B 5 Speed Usability in a 66K20

[Joe P]

Does anyone know the inside diameter of the bore in the butt end of a 292 crankshaft where the pilot bearing sits? I don't have one loose to look at. The 327 crank I have is 1.70 inches.

[jdl71]

Originally Posted by Joe P

Does anyone know the inside diameter of the bore in the butt end of a 292 crankshaft where the pilot bearing sits? I don't have one loose to look at. The 327 crank I have is 1.70 inches.

The pilot bushings are 1.093 od

[Joe P]

Originally Posted by jdl71

The pilot bushings are 1.093 od

Thanks for that information. This presents somewhat of a problem as the diameter of the pilot area on the input shaft is just under 1 inch. I am wondering if the Pilot bearing that is part of the set up Is pressed into the fly wheel and not the Crankshaft.