The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1973 - 1987 Chevrolet & GMC Squarebody Pickups Message Board

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 04-02-2020, 11:14 PM   #1
724wdcopper
graphic designer
 
724wdcopper's Avatar
 
Join Date: May 2004
Location: Spokane, Washington
Posts: 841
Painting 84 GMC grill

So I searched and see argent silver is the color recommended for the "silver" areas of the grill. but is that gloss? semi gloss? satin? flat?

And the black for the three center slat panels, also questioning semi gloss/satin/flat.

Those that have repainted their grill, what finish did you use?
724wdcopper is offline   Reply With Quote
Old 04-03-2020, 07:21 AM   #2
Pontiac1976
Registered User
 
Pontiac1976's Avatar
 
Join Date: Oct 2015
Location: Ottawa, Ontario, Canada
Posts: 766
Re: Painting 84 GMC grill

Most time the paint will be some degree of gloss but you do not want to put in on heavy your sort of misting the paint a little bit on the drier side of spray, same for satin. You can get paint mixed in flat /clear with satin. Do some pre-painting get the speed and distance that works best for you for both finishes. what comes closes to the look.

You do not want to put to heavy or to wet it can turn the paint to change wet look or / clear to go more glossy.
The Prep / cleaning /finish are going to be Key take your time then painting.
__________________
1977 REG cab Long Bed with a 1984 Front Clip, 82 305 .60 over 9.0.1 flat top pistons, 4bbl, TH350, w/84 SS-intake & cam , w/ 1977 big block rad, 1975 gear box, 1984 master w/ metric fittings top & SAE fitting @ portion block, 1975 3.42 gear open diff. Duel 77-87 Factory air cleaner, duel inlet from rad support . Down sized 9' to new 8' Steel flat bed
Was a 77 454 w/308 gear. Taken out 550 lbs. up front with motor clip change.
Pontiac1976 is offline   Reply With Quote
Old 04-03-2020, 09:46 AM   #3
blazer2007
Registered User
 
Join Date: Jan 2007
Location: vernon b.c.
Posts: 3,022
Re: Painting 84 GMC grill

I too picked up a 74 grill I want to clean up and paint but was wondering what to use to clean it with on final prep. I don,t want to use harsh thinners or others that might leach into the plastic and affect the paint bubbling or blisters etc.
blazer2007 is offline   Reply With Quote
Old 04-05-2020, 07:48 AM   #4
Pontiac1976
Registered User
 
Pontiac1976's Avatar
 
Join Date: Oct 2015
Location: Ottawa, Ontario, Canada
Posts: 766
Re: Painting 84 GMC grill

First I would clean with warm water light car wash ( soap) med to soft tooth brush. Keep it wet clean brush often. Dry use wax polish remover. Use blue shop towel keep turning to a clean area often wipe if a little wet dry with another towel in your other hand.
Well it depends on how deep the scratches on the grill fins or how much rot on the plastic do any work need just take the sheen off.
Spray down fins with water lightly sand 400 wet/dry paper if there still heavy scratches in the paint, if most of the scratches are very light sand with 800 wet/dry paper make sure it wet water down. (spray bottle or bucket water clean water the if it gets to milky)
When finished hose down with water let dry or blow dry.
Wipe down with SEM Products, and SEM soap cleaner, SEM wipes clean patches, #39863 SEM Plastic Adhesion Promoter and fallow there direction on all there SEM Products. Then mask off the grill what needs to be painted different color start with inside first and or dark color first, then lighter color outer side area last mask. After all most hard to dry pull your masking tape off let dry. Then the same for the second color area painted dry. Do your clear let dry. fallow there direction painting time temp drying time as close with taking in humidity in count. Let dry clean area, or bake in hot sun few hour turning every 1/2 for the cool the fins a little then put in side for a day or two or on truck. Do not wash do not use any harsh cleaners or soaps 60day then only mild clears soaps.
__________________
1977 REG cab Long Bed with a 1984 Front Clip, 82 305 .60 over 9.0.1 flat top pistons, 4bbl, TH350, w/84 SS-intake & cam , w/ 1977 big block rad, 1975 gear box, 1984 master w/ metric fittings top & SAE fitting @ portion block, 1975 3.42 gear open diff. Duel 77-87 Factory air cleaner, duel inlet from rad support . Down sized 9' to new 8' Steel flat bed
Was a 77 454 w/308 gear. Taken out 550 lbs. up front with motor clip change.
Pontiac1976 is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 12:13 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com