Smooth Firewall Fusebox Mount? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Dodge68charger · 04-29-2020, 01:26 AM

How Did You Guys Go About Mounting The Fuse Box To The Firewall n Routing The Wires?

Thanks Guys
Posted via Mobile Device

**1971Stepside** · 04-29-2020, 10:48 AM

I did two things. I made a piece that welded in my drivers side vent that will allow me to bolt the bulkhead of the wiring harness into it and run all the wiring out of the cab and up into the fender. I don't have a pic of that, but I also put this panel in on the backside of the firewall to allow me to mount my gauge wiring and other necessary items.

04-29-2020, 01:26 AM	#1
Dodge68charger Registered User Join Date: Jul 2014 Location: Washington Posts: 536	Smooth Firewall Fusebox Mount? How Did You Guys Go About Mounting The Fuse Box To The Firewall n Routing The Wires? Thanks Guys Posted via Mobile Device

04-29-2020, 10:48 AM	#2
1971Stepside Almost Satisfied Join Date: Mar 2002 Location: Springfield, MO Posts: 2,932	Re: Smooth Firewall Fusebox Mount? I did two things. I made a piece that welded in my drivers side vent that will allow me to bolt the bulkhead of the wiring harness into it and run all the wiring out of the cab and up into the fender. I don't have a pic of that, but I also put this panel in on the backside of the firewall to allow me to mount my gauge wiring and other necessary items. Attached Images __________________ 1971 C10 Stepside. LSx 6.0 with BTR Stage IV, Speed Engineering Headers, 4L80e transmission w/3200 Circle-D Stall. 3.73. Posi. Purchased this truck when I was 17. I started the rebuild (or take apart) in 1993. I have drug it around all over the country in pieces. Finally back on the road in 2021. "I can't complain, but sometimes I still do. Life's been good to me so far."



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.