|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
04-30-2020, 07:57 AM
|
#2 |
|
Senior Member
 
Join Date: Jun 2007
Location: Pine Ridge Florida
Posts: 4,188
|
Re: Advice for Hoist for K5 Top from Attic Trusses
Unistrut comes in 10' lengths. I would use 2 ten foot pieces to spread the weight out even more?
I am no structural engineer but worked commercial construction (electrician) for 40 years. Without seeing the garage or trusses I am just guessing here. Could you also run some threaded rod up from the Unistrut to another part of the truss/rafter? I have been told my stuff doesn't fall down but sinks into the ground from being over built?
__________________
Click on my Not really a build thread, yet NOT SO RUST FREE RUST FREE BLAZER LS ENGINE SWAP INFORMATION THREAD BOLT RESTORATIONS 4l60 to an NP205 |
|
|
| Bookmarks |
|
|
Threaded Mode