|
05-14-2020, 09:03 AM | #1 |
Senior Member
Join Date: Sep 2017
Location: Bryan, Texas
Posts: 2,292
|
Re: SBC headers?
Thanks all. I think I'm going to give the Patriots a try. I'll post up if they work.
__________________
8man-aka Robert 1948 on a S10 Frame, small block with a carb 1954 Cab, 53 Front and Bed, 50 Doors, S10 Frame, Power TBD Build thread: "]http://67-72chevytrucks.com/vboard/showthread.php?t=746899&highlight=wife%27s+48[/URL] [/URL]http://67-72chevytrucks.com/vboard/showthread.php?t=840204 |
05-24-2020, 04:56 PM | #2 |
Senior Member
Join Date: Sep 2017
Location: Bryan, Texas
Posts: 2,292
|
Re: SBC headers?
Ok, I put the Patriot H8036-1 headers on and this is what I have.
IMG_0539 by Robert Moorman, on Flickr IMG_0540 by Robert Moorman, on Flickr The riders side fits nice all hooked up to plugs and wires, good spacing. The drivers side fits and the steering shaft should fit through the tunnel, but the #1 plug cap is really close to the tube and the collector is really close to the tranny. I'm not sure what to do about the plug cap, but once installed, I think the collector will miss the tranny be enough to be safe.
__________________
8man-aka Robert 1948 on a S10 Frame, small block with a carb 1954 Cab, 53 Front and Bed, 50 Doors, S10 Frame, Power TBD Build thread: "]http://67-72chevytrucks.com/vboard/showthread.php?t=746899&highlight=wife%27s+48[/URL] [/URL]http://67-72chevytrucks.com/vboard/showthread.php?t=840204 |
Bookmarks |
|
|