|
Re: 1982 GMC Header Panel adjustment
They could be right about the cab, but did you have any shims at the front of the fenders before took of the rad support. ( are they after market fenders and or rad support you may need shims on one side or both. But I would make sure the cab is sitting square. If it is try shims between fender and rad support as needed to correct the fit.
__________________
 1977 REG cab Long Bed with a 1984 Front Clip, 82 305 .60 over 9.0.1 flat top pistons, 4bbl, TH350, w/84 SS-intake & cam , w/ 1977 big block rad, 1975 gear box, 1984 master w/ metric fittings top & SAE fitting @ portion block, 1975 3.42 gear open diff. Duel 77-87 Factory air cleaner, duel inlet from rad support . Down sized 9' to new 8' Steel flat bed
Was a 77 454 w/308 gear. Taken out 550 lbs. up front with motor clip change.
|
10-07-2020, 01:40 AM
Threaded Mode