|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
12-23-2020, 11:37 AM
|
#1 |
|
Registered User
Join Date: Nov 2020
Location: Perry, UT
Posts: 5
|
Rear end tag straightening
Morning all, looked around a bit and didn't see what I was looking for. I took the rear end tags of off my 1972 GMC C20. Has dana 60, with 4.10 limited slip. I cleaned the rust with CLR and a brush, the limited slip tag is crinkled, any way of flattening, straightening it without ruining the stamping on it?
|
|
|
|
12-23-2020, 11:47 AM
|
#2 |
|
Registered User
Join Date: Jan 2017
Location: Valley, NE.
Posts: 1,018
|
Re: Rear end tag straightening
I would put it in a vice with 2 pieces of soft pine against the jaws.
Greg
__________________
________________ 1970 GMC Sierra Grande, 2500 133" wb, 402, 4spd. 2007 GMC 3500 SRW 4x4, Crew cab, Duramax/Allison. (Sold} 1987 Chevy Suburban 2500, Silverado, 2wd, 454, t-400 2023 Chevy Silverado LT 3500, crew cab, longbox, 4x4 Z-71 Duramax. |
|
|
|
|
12-24-2020, 12:13 AM
|
#3 |
|
Senior Member
 
Join Date: May 2010
Location: Wisconsin & Arizona
Posts: 4,852
|
Re: Rear end tag straightening
I'd probably put it on a hard, solid flat surface (think the anvil portion of your vice or piece of 1/4" thick steel) with the raised lettering upward. Then take something like a piece of steel bar stock thin enough to place on edge between the lines of lettering and tap with a hammer. Even a wood paint stirrer may work.
__________________
Jim |
|
|
|
| Bookmarks |
|
|
Linear Mode
