Ford 8.8 rear end

[LS short box]

I have a 8.8 Explorer rear end in my LS swapped 98 Wrangler. It stock with 31 spline axles and posi. As said above it is a very popular upgrade to the Dana 35. The pinion offset wasn't a problem since I had constant velocity drive shaft built. The e-brake isn't the best design but it will hold the Jeep on an incline.
If you go this route be careful as you cut off the old brackets. The axle tubes a bit thin.

[Sam1968 PNW]

Originally Posted by LS short box

I have a 8.8 Explorer rear end in my LS swapped 98 Wrangler. It stock with 31 spline axles and posi. As said above it is a very popular upgrade to the Dana 35. The pinion offset wasn't a problem since I had constant velocity drive shaft built. The e-brake isn't the best design but it will hold the Jeep on an incline.
If you go this route be careful as you cut off the old brackets. The axle tubes a bit thin.

Thx but I think I’ll go with a gm 12 bolt, I’ll just take my time and see what pops outta the woodwork!
Posted via Mobile Device