|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
03-10-2021, 06:53 PM
|
#1 |
|
Registered User
Join Date: Jul 2010
Location: jacksonville nc
Posts: 1,229
|
Cranks on run and crank/gauge question
At it again, I pulled my old harness and putting in a new bp automotive harness, I was hooking up the starter and solenoid wires, now it cranks in the run and crank position. Has anyone else encountered this problem? I did have a issue with the neutral safety switch before. I havnt fully wired up the gauges and inside of my cab. This is kicking my butt.
Second question I just bought a autometer 7004 lcd gauge cluster, I was running autometer electric gauges before, are those sending units still the same?
__________________
Sgt Dennis Heineman USMC Aviation Ordnance I.Y.A.O.Y.A.S 2001-Present 84 K10 2000 trans am ws6 2011 nissan altima 2009 Troy Built with a 42 Inch Deck  My LS Swap http://67-72chevytrucks.com/vboard/s...=1#post6559371 |
|
|
|
03-10-2021, 09:22 PM
|
#2 |
|
Post Whore
  
Join Date: May 2015
Location: Alabama
Posts: 14,673
|
Re: Cranks on run and crank/gauge question
might check the wire connections for the switch sound your your switch on and crank are touching or connected wrong..
__________________
Mongo...aka Greg RIP Dad RIP Jesse 1981 C30 LQ9 NV4500..http://67-72chevytrucks.com/vboard/s...d.php?t=753598 Mongos AD- LS3 TR6060...http://67-72chevytrucks.com/vboard/s...34#post8522334 Columbus..the 1957 IH 4x4...http://67-72chevytrucks.com/vboard/s...63#post8082563 2023 Chevy Z71..daily driver |
|
|
|
|
03-12-2021, 08:19 AM
|
#3 |
|
Senior Member
 
Join Date: Feb 2014
Location: new smyrna beach fl / 29 palms cal
Posts: 1,727
|
Re: Cranks on run and crank/gauge question
You might also check your wires on the plug to make sure they’re in the right place my headlight switch from them came miss wired
__________________
Hand made A/C vent manifolds for 64-66 trucks adapts any aftermarket A/C to OEM vent |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
