MO WTB radiator core support - The 1947 - Present Chevrolet & GMC Truck Message Board Network

64 rust · 04-25-2021, 12:22 PM

Hey guys, looking for a decent radiator core support for my 64, the bottom of mine was all rusted out. Would rather not buy new, but if I have to go that route any suggestions on best fitting would be appreciated! Thanks guys!

**cwcarpenter98** · 04-25-2021, 02:38 PM

I also looked for a while for a good, original one. By the time I finally decided I needed to fix mine, the passenger side where the mounting bolt goes through had completely rusted out and broke off. The driver's side was well on it's way to doing the same thing

Anyways, I decided to buy a new one from Auto Metal Direct since I could go to their warehouse and pick it up to save on shipping. I have all original GM sheet metal for the rest of my front end, but the core support still fit perfectly. I did not have to hog out any holes to get the panels to line up. I am very happy in my choice with that panel. The amount of time I saved on not trying to repair my original was well worth the money I spent on the new one

64 rust · 04-25-2021, 04:10 PM

Thanks for the response, I might have to go that direction. Good to know about the fit!

04-25-2021, 12:22 PM	#1
64 rust Registered User Join Date: Dec 2017 Location: St. Louis, mo Posts: 69	WTB radiator core support Hey guys, looking for a decent radiator core support for my 64, the bottom of mine was all rusted out. Would rather not buy new, but if I have to go that route any suggestions on best fitting would be appreciated! Thanks guys!

04-25-2021, 02:38 PM	#2
cwcarpenter98 Senior Member Join Date: Jan 2018 Location: Hickory Flat, GA Posts: 4,488	Re: WTB radiator core support I also looked for a while for a good, original one. By the time I finally decided I needed to fix mine, the passenger side where the mounting bolt goes through had completely rusted out and broke off. The driver's side was well on it's way to doing the same thing Anyways, I decided to buy a new one from Auto Metal Direct since I could go to their warehouse and pick it up to save on shipping. I have all original GM sheet metal for the rest of my front end, but the core support still fit perfectly. I did not have to hog out any holes to get the panels to line up. I am very happy in my choice with that panel. The amount of time I saved on not trying to repair my original was well worth the money I spent on the new one __________________ Christian Carpenter 1963 C10 - Frankentruck 283, Muncie 3 speed with overdrive Overdrive wiring here 1963-ish truck bed trailer - Half-Wit 1981 C10 - Penny 305, th350 --> Soon to be 350, Saginaw 4 speed 1995 Dodge Dakota Sport "I'll put it simple: if you're going hard enough left, you'll find yourself turning right." - Doc Hudson

04-25-2021, 04:10 PM	#3
64 rust Registered User Join Date: Dec 2017 Location: St. Louis, mo Posts: 69	Re: WTB radiator core support Thanks for the response, I might have to go that direction. Good to know about the fit!



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.