|
07-14-2004, 09:17 PM
|
#1 |
|
Registered User
 
Join Date: Apr 2000
Location: Bradenton, FL
Posts: 1,036
|
Center console ?
Does the center console bolt right to the floor or does it bolt to a brecket that bolts to the floor?
__________________
1970 CST/10 402,700R4,3:73 posi,AC,PS,PB,TLT,PW,Buckets with heaters |
|
|
|
07-14-2004, 10:10 PM
|
#2 |
|
The Blazer King
Join Date: Sep 2000
Location: Valrico, Fl (Tampa)
Posts: 1,212
|
Mine has 4 holes and bolts right through the floor. This is on both my Blazers.
__________________
72 2wd Blazer. Its the superbichinest, megacoolinest, superflowinest. |
|
|
|
|
07-14-2004, 10:34 PM
|
#3 |
|
Account Suspended
Join Date: Sep 2000
Posts: 3,991
|
At the front end of the console on the bottom it steps up a bit. That area rests centered on the part circled in red. I circled the holes in black. Basically to install it, place it on the floor on that step up, and center it, mark and drill your holes.
|
|
|
|
|
07-15-2004, 07:45 AM
|
#4 |
|
Senior Member
Join Date: Jun 2001
Location: Shelbyville, KY
Posts: 3,261
|
There is a plastic bracket or spacer of sorts that is often used with these consoles. I can't remember if they were on Blazer's or trucks but I have had several over the years. The console's all had four pre formed holes in their bottom area and none lined up with this spacer so I would guess that it was more of a brace then anything else. You could probably just use a piece of wood but bracing a plastic console is kind of wasted cause if you sit on it, it brakes. Now getting a 110lb young lady to kind of stretch across it in some form is another story ---for another time---on another board! hehehehe
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
