|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
06-19-2021, 10:52 AM
|
#13 |
|
Mr. Cheyenne
 
Join Date: Jun 2020
Location: Kyle, Texas
Posts: 1,703
|
Re: AC/Heater User Fan Control - Melted Connector & Frozen Switch
Well, I revisited the relay again this morning. The back screw really wasn't fastening down good and allowed the relay to flop a bit from that back. I figured that movement would cause the front screw to loosen over time. I found a good larger screw that tighten properly. I also cleaned up the ground a bit more and all the connections got a little dab of dielectric grease.
I shouldn't need to get under there again or at least not for that relay.
__________________
Richard '72 Chevy C10 Cheyenne *Super WHT/MED BRONZE/WHT SBC 350 | TH350 | LWB | AC | Buddy Seats Upgrades: Tilt | Front Sway Bar | Radio | Sliding Window | Bed Spare w/Lock Bed Rails | Full LEDs | Courtesy Lights | Tachometer | Glovebox Lock & Light | Head Light Relays | *Upgraded Fully Super Trim |
|
|
| Bookmarks |
|
|
Threaded Mode