Narrowed Rear With OE Trailing Arms? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

JDon99 · 11-03-2021, 11:42 AM

I'm gathering up parts for my 66 SWB street/strip build, and looking to have a 9 inch built by Strange for the trialing arm setup. I was considering going slightly narrower than the stock width(2" per side). Have any of you guys ran a setup like this? I just want to make sure there won't be any clearance issues. Thanks fellas!

SCOTI · 11-03-2021, 04:58 PM

Quote:

Originally Posted by JDon99

I'm gathering up parts for my 66 SWB street/strip build, and looking to have a 9 inch built by Strange for the trialing arm setup. I was considering going slightly narrower than the stock width(2" per side). Have any of you guys ran a setup like this? I just want to make sure there won't be any clearance issues. Thanks fellas!

At 2" per end, you shouldn't run into any issues. E-brake cable routing/attachment might require finesse depending on the set-up (might).

JDon99 · 11-03-2021, 05:30 PM

Quote:

Originally Posted by SCOTI

At 2" per end, you shouldn't run into any issues. E-brake cable routing/attachment might require finesse depending on the set-up (might).

I'll probably go with a set of Wilwoods with a. 11 or 12" rotor.

11-03-2021, 11:42 AM	#1
JDon99 Registered User Join Date: Sep 2012 Location: Desoto, MO Posts: 28	Narrowed Rear With OE Trailing Arms? I'm gathering up parts for my 66 SWB street/strip build, and looking to have a 9 inch built by Strange for the trialing arm setup. I was considering going slightly narrower than the stock width(2" per side). Have any of you guys ran a setup like this? I just want to make sure there won't be any clearance issues. Thanks fellas!



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.