67 C10 door locks

[LockDoc]

Originally Posted by ToonMan

I pushed it and it works fine!!! Thank you

That means one of two things. The latch is worn out or you need to move your striker plate out about 1/16 of an inch. If you move the striker plate out mark around it with a fine felt tip marker first and don't let it move up or down, just out.

Originally Posted by special-K

That's funny! I was going to say "sounds like they work as designed. enter driver side and exit passenger", but figured he might not feel like joking until he got it figured out.

....

LockDoc

[ToonMan]

Excellent Lock Doc. Thanks

[LockDoc]

Originally Posted by ToonMan

Excellent Lock Doc. Thanks

No problem. Post an update after you figure out a permanent cure.

LockDoc

[ToonMan]

Originally Posted by LockDoc

No problem. Post an update after you figure out a permanent cure.

LockDoc

I'll check the striker plates tomorrow!!! Appreciate the help!!!!

[ToonMan]

Originally Posted by LockDoc

No problem. Post an update after you figure out a permanent cure.

LockDoc

Only adjusted the striker plate and it didn't seem to make any difference. I still have to slightly push in on the door and then it will lock. But thanks for the advice though cuz I'm very open.

[LockDoc]

Originally Posted by ToonMan

Only adjusted the striker plate and it didn't seem to make any difference. I still have to slightly push in on the door and then it will lock. But thanks for the advice though cuz I'm very open.

Adjust it out another 1/16th then.

LockDoc