Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
|
05-26-2022, 08:15 AM | #1 |
Senior Member
Join Date: Mar 2014
Location: Toano, VA
Posts: 849
|
Re: My 1967 Build (Finally)
And after some fitting and minimal shaping, the rocker is in. I kind of hopped around while welding, to dissipate heat and ensure the rocker wasnt getting out-of-whack during the job. It fits well - the rocker to cab corner area is a bit off, but none more than the factory would have been, so Im okay with it. The intent with the truck comes down to the word 'close'. I want it all close, too clean and it would be out of place, this is a patina-drive-anywhere truck, not a show stopper.
Im happy with it all. Also, burned in the front floor pan and kick panel, I need to grind it down, which Ill do on one of my grind-days.
__________________
"Sometimes I do serve as a good bad example. Glad to be of service." My Build Thread (1967 C10, lowered, EFI, daily truck): http://67-72chevytrucks.com/vboard/s...d.php?t=830809 |
Bookmarks |
Tags |
1967, custom, dropped, lowered |
|
|