![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#8 |
Senior Member
![]() Join Date: Dec 2009
Location: TN.
Posts: 7,902
|
Re: 208 Transfer Case Rebuilt Kit/ Bearing,Chain&Gaskets
That will work
![]() I welded up a fixture to use on a floor jack years ago, To put a transfer case in cause of a no helper issue. ![]() Sometimes I have spare time at work, While my machine has long run times ![]() You heard the old saying (Idle Hands) ![]() So, this is where that began. ![]() Access to a milling machine behind the Big machine I run. And a scrap plate of aluminum. And then This. I will probably finish it up tomorrow. It's supposed to get up to 60 degrees. I will use threaded rod and spacers for the holding/leveling. My parts are scheduled to be here Tuesday. I hope to show my Nephew this process. That is part of the reason for the extra effort.
__________________
________________________________________________________________________________________ ____________________________________________ 84 Chevy K-20 63 Impala (my high school car) http://67-72chevytrucks.com/vboard/s...Crew Cab Build |
![]() |
![]() |
Bookmarks |
|
|