Nv4500 swap

[LockDoc]

Originally Posted by Tomo

Hey Leon - Yes I did see your thread in my search. Great idea on redrilling the trans. Still happy with the nv4500? Did you use your factory crossmember?

I am gathering the parts to put an nv4500/np241 in my 70 k5. Should be able to mock everything up once the 32 spline input shaft for the 241 comes in. I think all that will be left is to figure out my crossmember.

It is still working great and I use it a lot.

I just used the bell housing cross member mount I don't have a rear transmission cross member. Normally, three engine/transmission mounting points is not recommended, at least on the 2wd. I don't know about the 4x4's, but I would think a stock cross member would work if you need one.

LockDoc