'66 Budget friendly driver

[cwcarpenter98]

You have a sweet truck!
I just got done swapping in a 3 speed overdrive trans, and I replaced the tail shaft seal while it was out. When I looked inside the trans, I saw the bearing/bushing thing that the driveshaft slips in to. It looked like you could remove it without pulling the tailshaft housing off the transmission. I think you should be able to replace it without dropping the transmission, but I'm not 100% sure because I haven't replaced mine.
I had a 3 speed, long tail shaft trans in mine before swapping to the overdrive version, and I must say that it is stupid easy to get in and out of the truck. It was light enough for me to pull it out and put it back in without using a jack.
If you are talking about the mainshaft bearing, than I would go ahead and pull the transmission.

The QA1 system looks great, but this college student can't afford that lol. I was wondering how your old system rode in comparison to stock. I am considering a 2/3 drop for mine since I need to replace the original coil springs anyways

[olrosa]

Originally Posted by cwcarpenter98

You have a sweet truck!
I just got done swapping in a 3 speed overdrive trans, and I replaced the tail shaft seal while it was out. When I looked inside the trans, I saw the bearing/bushing thing that the driveshaft slips in to. It looked like you could remove it without pulling the tailshaft housing off the transmission. I think you should be able to replace it without dropping the transmission, but I'm not 100% sure because I haven't replaced mine.
I had a 3 speed, long tail shaft trans in mine before swapping to the overdrive version, and I must say that it is stupid easy to get in and out of the truck. It was light enough for me to pull it out and put it back in without using a jack.
If you are talking about the mainshaft bearing, than I would go ahead and pull the transmission.

The QA1 system looks great, but this college student can't afford that lol. I was wondering how your old system rode in comparison to stock. I am considering a 2/3 drop for mine since I need to replace the original coil springs anyways

Thank you. You will be happy with a 2/3 drop. It will ride fine. The QA1 stuff makes the cornering 100 times better that stock

[cwcarpenter98]

Originally Posted by olrosa

Thank you. You will be happy with a 2/3 drop. It will ride fine. The QA1 stuff makes the cornering 100 times better that stock

Thanks! Maybe once I graduate from college, I'll be able to get some goodies. For now though, I need to replace the original springs anyways

[olrosa]

Please note that you must be a supporting member to post classified items. This includes but is not limited to What Its Worth, Want To Buy, Want To Trade, and For Sale. Please consider supporting the forum by subscribing. Further information on the subscription levels available are located here

If you need any further assistance with that please contact any Admin for help.

[olrosa]

Well it sounds like it's sold to a great guy out in MD. Kinda bummed

[PowerdbyChevy79]

Any updates?

[olrosa]

Originally Posted by PowerdbyChevy79

Any updates?

I sold it a couple of years ago. Miss it like crazy. I still talk to the guy. He just finished putting a LS in it.