![]() |
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
#20 |
|
Mr. Cheyenne
![]() Join Date: Jun 2020
Location: Kyle, Texas
Posts: 1,703
|
Re: Rebuilding / Installing Hinge Pillar to Fender Seal
Got a good match for screws and a so-so "spacer" off Ebay. The spacer is slightly bigger but it will work well enough.
Amazon Prime - pack of 25 for $9.16 shipped 18-8 Stainless Steel Sheet Metal Screw, Black Oxide Finish, Hex Washer Head, Hex Drive, Type AB, #10-16 Thread Size, 1/2" Length Ebay - Pack of 10 for $10.81 shipped Specbolt M6x18 Shoulder Washer Motorcycle Plastics Collar Bushings
__________________
Richard '72 Chevy C10 Cheyenne *Super WHT/MED BRONZE/WHT SBC 350 | TH350 | LWB | AC | Buddy Seats Upgrades: Tilt | Front Sway Bar | Radio | Sliding Window | Bed Spare w/Lock Bed Rails | Full LEDs | Courtesy Lights | Tachometer | Glovebox Lock & Light | Head Light Relays | *Upgraded Fully Super Trim Last edited by Rich72C10; 08-18-2023 at 03:53 PM. |
|
|
|
| Bookmarks |
|
|