|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
08-15-2004, 10:48 PM
|
#1 |
|
Registered User
Join Date: Dec 2003
Location: Morgantown, KY
Posts: 103
|
Putting spindles on...what to replace?
I'll be installing my DJM spindles here pretty soon. I figure since i'll have the front end tore apart, i ought to replace bearings, bushings, etc...
What all should i check/replace? |
|
|
|
08-16-2004, 02:14 PM
|
#2 |
|
What I drive
Join Date: Apr 2004
Location: Star, MS
Posts: 418
|
bearings, upper and lower control arm bushings, upper and lower ball joints, tie rod ends. hope that helps
__________________
1986 Chevy Crew Cab Dually(Choo-Choo Conversion) 2006 Chevy Equinox |
|
|
|
|
08-16-2004, 03:23 PM
|
#3 | |
|
Insert Witty Text Here
Join Date: Oct 2002
Location: San Antonio, TX
Posts: 3,415
|
Quote:
Slonaker |
|
|
|
|
|
08-16-2004, 11:49 PM
|
#4 |
|
Registered User
Join Date: Dec 2003
Location: Morgantown, KY
Posts: 103
|
thanks guys
|
|
|
|
|
08-16-2004, 11:52 PM
|
#5 |
|
Registered User
Join Date: May 2004
Location: Lubbock, Texas
Posts: 2,121
|
get a supesion rebuild kit, but thats just me
__________________
'96 Nissan Pathfinder '02 Firebird Trans Am. '88 K5 Blazer |
|
|
|
|
08-17-2004, 12:02 AM
|
#6 | |
|
Garage Queen Material
Join Date: Oct 2002
Location: USA
Posts: 4,129
|
Quote:
yes. and use plenty of bearing grease, or else you will regret it later and need to buy new spindles 
|
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
