Pass. Upper shock bolt hole

[mongocanfly]

I looked at a bunch of frame drawings, none show shock location
Could you not measure drivers side and mirror it to pass side?

[kwmech]

Should be a dimple in the frame, I'd find the center of it and drill and watch out for the brake line behind it

[rodstored-72]

Originally Posted by kwmech

Should be a dimple in the frame, I'd find the center of it and drill and watch out for the brake line behind it

KWMECH, thanks for the reply. I had to do a repair in the area - the OG hole was "torn" and the shock was moving front to back. you can see the problem in my build thread. I THINK my issue is the switched positions on the axle housing???

[kwmech]

Link to build thread?

[rodstored-72]

Originally Posted by mongocanfly

I looked at a bunch of frame drawings, none show shock location
Could you not measure drivers side and mirror it to pass side?

Mongo, thanks for the reply. I believe that is what I did when I originally did the frame repair, but the shock is at a sharper angle than the drivers & appears to "push" up the pass side about 1/2" the rear is higher on pass side. the shocks are reversed on the axle housing.... ddooohhh!!