V8 engine mounts for a 62 c10

[62 Barnfind]

Attachment 2382991I just did the 78 crossmember swap with CPP spindles and I’m looking for the correct engine mounts that will fit. My friend gave me a set of CPP engine mounts but they don’t seem to fit right. Seemed a little tall. I’m doing the research to see what’s the best fit and what I need to use. I’m still running the grand bell housing crossmember with a 62 V8 bell housing. Attachment 2382991

[62bagger]

I have 64 X member in my 62 and I used the 67 - 72 motor mounts. They bolted to the frame without the spacer on top of the frame. I tried the tube type of mounts and they sat too high and they also needed a spacer on top of the frame.

[62 Barnfind]

That’s what I needed. Where did you get them? Did you move your steering gear box forward? My drag link is real close and high on the x member. When I installed the x member the front two holes lined up so I went with that. How was your install?

[62bagger]

It has been a while since I bought them. I think I got them from Brothers (not positive). I used the steering box from a late 70's C10 and captain fabs mounting bracket. I have plenty of clearance for the steering components.