|
08-26-2004, 12:14 AM
|
#1 |
|
Registered User
Join Date: Feb 2003
Location: California
Posts: 73
|
Wheel backspacing??
i am in the process of getting some new wheels and tires for my truck. I have a 1971 short stepside 4x4. i plan to buy the 15x10 mickey thompson classic II wheels and the 33x12.50x15 BFG mud terrains. i have the 12 bolt 6-5.5 rear end and the dana 44 front. what would be a good back spacing for this tire wheel combo? i don't want them to stick out too far but maybe just out side the fenders. the truck will also be getting a 4'' lift soon after the new tires if that helps any.
Thanks in advance Tom |
|
|
|
08-26-2004, 06:36 AM
|
#2 |
|
user # 2756
 
Join Date: Jun 2001
Location: Chesapeake, Virginia
Posts: 4,612
|
Most are 3.5" to 4.25".
__________________
1970 K25, 8' stepside bed 350/465/205 44 up front, 60 in the rear 4.10s rolling on 33" Dunlop MTs 1986 K5, 350/465/208 Dana 60/14 bolt from a cucv 36" Super Swampers TSL/SX 1983 K20 w/ CUCV axles, 350/700R4/208 sitting on 37" Goodyears 1986 M1031 6.2 diesel, TH400/NP205 locker in the rear and a LS in the front, all stock for now..... 1986 K30, 350/400/205 dana 60 and 14 bolt. I kept the drivetrain. Body/bad and chassis are gone. 1981 K30, 350/465/205 dana 60 and dually 14 bolt. Has a G80, and a flat bed. Going to replace the flat bed. 1985 K20, 350/400/208 10 bolt and SF 14 bolt. I wonder where I can find some 1 tons. Hmmmmm 
|
|
|
|
|
08-26-2004, 06:53 AM
|
#3 |
|
Registered User
Join Date: Dec 1999
Location: Old Mission, MI, USA
Posts: 2,507
|
Stock 15X8 rallies are 3 1/2", so 4 1/2" would retain the factory offset. 4 1/4" would be fine.
__________________
Tim |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
