Best complete high hump floor pan

[Rg500gamma]

After looking at countless YouTube floor replacement videos and one stated to stay away from the LMC replacement floor. So, I figured I would ask the members on here what they consider the best and closest to OEM floor to go with.
Thanks ahead for all your opinions

[LS short box]

Afraid I'm not much help but I bought the high hump from a vendor on this site. I'm betting they are all sourced from the same over seas supplier.
I don't recall having any big issues with the install. I bolted mine in and used caulk material to seal it to the floor.
I had to add the high hump because I was running a T56 magnum.
Pic after insulation installed.

[franken]

LMC, like most doesn't make anything so saying not to buy their stuff is meaningless. All of the places you buy body parts from sell stuff made in Asia by who knows who. There are not very many manufacturers and you have little chance of knowing who made a part and if it's any better than another. AMD claims to make some parts but it's hard to say if they do.

[best view]

I’ve never had a bad experience with lmc

[Orefactory4x4 swb]

I bought my full high hump from lmc and was pleased with it. A little banging around hear and there.

[Jason Banks]

Here's a thread about floors - https://67-72chevytrucks.com/vboard/...d.php?t=848263

I do recall hearing something about the LMC floors having some problem. But, there is someone in that thread that said the LMC worked good for them.

[Jason Banks]

You should consider gmcpauls.com

He's a board supporter and will tell you what he knows about the different floors, and tries to only sell ones he knows are good....

[Rg500gamma]

I saw GMC Paul's site and did see AMD and KEY stampings available
I am going to have a look at the above thread
I appreciate the help from you guys and will keep on top of other members comments. KNOWLEDGE IS GOOD !
Also help me from screwing up and redoing the floor

[Orefactory4x4 swb]

Nice, I can tell you this, which i learned on here. Get lots of measurements before cutting out old oe. And some good bracing, I did mine and it went pretty good for me.

[Rg500gamma]

The LMC floor video I watched, the guy stated that it did not come with the 2 fork like stanchions attached at the front which in turn
match up to the lower firewall stanchions.
I also see GMC PAUL is a Dynacorn reseller as well. I will get there advice as well. The LMC floor commentor was MAYCO Fab I believe.

[Jason Banks]

Here's the video, about 2 1/2 minutes in he talks about the LMC high hump...

https://www.youtube.com/watch?v=6D3YOXS1Pd0

[Rg500gamma]

Thanks. He has apparently done a few 67-72 trucks. But seeing the products from GMC PAUL I have a good feeling they will know my answer almost immediately. The other items are the lower A and B pillars as I have also seen those on YouTube with slightly different stamping bends. And like most of us who love this series of the C and K, blazer/suburban want our pride and joys as close to production line stock as we possibly can

[Rg500gamma]

E anyway as I have a numbers matching truck.
No LS swap for me