Help with woodgrain matching

[zicc1835]

Originally Posted by 1972CheyenneSuper

I had the same issue when I ordered a new aluminum applique. I personally prefer the woodgrain pattern as shown on your bezel versus the larger and lighter grain of the original pattern. So I ended up applying a new decal to my new applique. End result took me three decals to get it applied with minimal bubbles. If I did it again, I would probably take it to a sign shop to have them apply it. All I had was a heat gun to get the bubbles out, and the first trial ended up shrinking an area that I couldn't make right again. I found the first one at Holley.com and the subsequent ones at classicparts.com. They are the same part, just a little cheaper at classicparts. These are the oversized ones for no trim panel, and that gives a little extra meat on the edges for trimming.

With that said, I do recall seeing a part number in a past search for the original vinyl that was close. It will take a little digging, but there was one somewhere in these forums.

just have to say the whole interior dash color, wood grain , seats and rug door panels combination is a spectacular combo IMHO