Distributor/Spark Plug Setup

[ahoke]

Went to replace the plugs/wires on my '72 with a 350. Curious if this looks correct (picture taken before removing the old wires). Seems like from my I can find online wire 1 is in spot 8? If so what effect does this have on the engine/performance? Obviously going to correct it but just curious.

[pjmoreland]

It looks like the distributor was just installed with the rotor clocked a little more clockwise than normal. It is irrelevant from a functionality standpoint. It would be a hassle to adjust it at this point if all you're wanting to do is replace your plug wires. You would have to set the crank at TDC, pull the distributor out of the block, rotate the oil pump shaft a little with a long screwdriver and then go through the trial and error process of reinstalling the distributor repeatedly until you get the rotor pointing in the direction you want #1 to be. You'd need to readjust the timing with a timing light afterward. Probably not worth the effort.

[ahoke]

Appreciate the response. Basically, just reinstall the new wires to match what they looked like before then?

[pjmoreland]

Yes, assuming the current wires are installed in the correct 1-8-4-3-6-5-7-2 order.

[1970 CST Short Wide]

Best way is One at a time so you don’t get mixed up.

[Rust_never_sleeps]

There is a conventional way that most folks clock their distributor, but no reason it has to be done that way.
I found this out the first time I swapped plug wires

[1970cstblazer]

To prevent cross firing, try not to have the wires touch each other.

[Myself]

Originally Posted by 1970cstblazer

To prevent cross firing, try not to have the wires touch each other.

I think that's an old wives tale going back to old fashioned plug wires. I can't see any way for the newer thick silicone jacketed wires to cross fire each other. There's a much higher chance of carbon tracking inside the cap causing a misfire than wires touching or laying on each other.

[RichardJ]

Rules of physics may not agree. Current in one wire will generate a magnetic field and cause current to flow in a parallel wire.

[Steeveedee]

^ While this is true, the wires would have to be parallel for awhile for enough counter EMF to make a crossfire, and the magnetic field tapers off exponentially. Most wires these days have a wire winding around the conductor, ADDED- or has the coil right on the spark plug, /ADDED which minimizes those fields. The wires on my truck are like that. It was an issue back in the day, though, for sure.

[Stanco]

Your distributor is installed correctly with #1 in between the vacuum advance can and the points adjustment window.

Now some folks will tell you that the #1 terminal should be pointing at the #1 cylinder. While this is correct for the HEI distributor this is not the way GM installed the earlier window points distributors.

Check out the assembly manual.

[Steeveedee]

I'm liking View E- "Clips on line perpendicular to axis of engine", though they did misspell perpendicular on the drawing. Perpendicular makes sense, for best access to the clips.