|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
01-07-2025, 12:58 AM
|
#2 |
|
Senior Member
 Join Date: Mar 2003
Location: Colfax-California
Posts: 8,941
|
Re: NP205 output shaft swap
Yup, just pay attention to the pocket bearing needles on the inside of the output gear when you pull it out. They will still get jumbled up, but pay attention to them falling down inside the case. Tip the case back as far as you can without it falling off the bench. That case appears to be a round 6 bolt case adapter mounting as it is worth some bucks
|
|
|
| Bookmarks |
|
|
Threaded Mode