|
Yesterday, 08:32 PM
|
#1 |
|
Active Member
 Join Date: Oct 2011
Location: Benton ar
Posts: 189
|
250 manifold install
I have several clamps that I believe are for the intake. The exhaust manifold has holes for studs Do clamps go on these as well.
If anyone has some schematics they could post, it would be much appreciated.
__________________
Joey Last edited by Dude68; Yesterday at 09:08 PM. |
|
|
|
Yesterday, 09:38 PM
|
#2 |
|
State of Confusion!
 
Join Date: Jul 2002
Location: Gulfport, MS USA
Posts: 47,428
|
Re: 250 manifold install
2 end uholez go on stud. The rest of the intake exhaust manifold share a special clamp and nut.
__________________
Bill 1970 Chevy Custom/10 LWB Fleetside 2010 Toyota Tacoma PreRunner SR5 Double Cab - DD Member of Louisiana Classic Truck Club (LCTC) Bill's Gallery Life isn't tied with a bow, but it's still a gift. Live simply. Love generously. Care deeply. Speak kindly. Leave the rest to God! |
|
|
|
|
Yesterday, 10:52 PM
|
#3 |
|
Active Member
Join Date: Oct 2011
Location: Benton ar
Posts: 189
|
Re: 250 manifold install
I got a pic off Chevy nova forum, I had it figured right. I had to take intake that I purchased to a machine shop to have a sheared bolt removed from where it bolts to exhaust. The guy suggested machining the area on intake heat exchanger then changed his mind and suggested using a good amount of gasket sealer on installation on it since machining it ma create a big gap. The intake area has some pitting. The old intake is pitted as well. Could 2 gaskets be used together? It has me a little worried.
__________________
Joey |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
