|
09-01-2004, 11:20 PM
|
#1 |
|
Senior Member
Join Date: Jun 2002
Location: Augusta Missouri
Posts: 804
|
uneven rear springs ?
I have new 4" drop springs in my 67 SWB, one side of the bed is 3/4" higher than the other. I would like the higher side to match the other. How can I fix this ? I was thinking about clamping a couple of coils together to lower it. Anybody done this? I have seen spacers for raising them but have never seen clamps for doing this. Thanks for the help
|
|
|
|
09-01-2004, 11:23 PM
|
#2 |
|
Got Light Emitting Diode?
Join Date: Apr 2004
Location: Newberg, OR
Posts: 2,485
|
like a small ubolt with a bar across and nutz to tighten it down? thats what i have pictured
__________________
1968 1/2 ton 2wd lwb 6 lug disc and bags up front. Next c notch and rear bags '02 Chevy Silverado LT ext cab short bed 2WD 5/7 drop on 22's  (the family car)1993 Cherokee work ride/weekend wheeler |
|
|
|
|
09-01-2004, 11:26 PM
|
#3 |
|
Senior Member
Join Date: Jun 2002
Location: Augusta Missouri
Posts: 804
|
Thats what I'm thinking also, has to be the springs making it uneven, nothing else there.
|
|
|
|
|
09-02-2004, 12:21 AM
|
#4 |
|
Before and After
Join Date: Feb 2000
Location: Leduc, Alberta CANADA
Posts: 632
|
Be sure to check the frame Height, I had the same problem, and it turned out to be the crossmembers of the box were our of whack, I ended up changing those to correct the Droop in the one side.
Good luck.
__________________
Not Grandpa's C-20 anymore... 383 Stroker 425HP, 485Ft/Lbs Lowered 3.5" Front / 5" Rear 66,000 miles. Alberta, CANADA |
|
|
|
|
09-02-2004, 09:08 AM
|
#5 |
|
Senior Member
Join Date: Jun 2002
Location: Augusta Missouri
Posts: 804
|
I'll do that, How was your crossmember out of whack ?
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
