I replaced the steering wheel - the horn didn't work - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**IT Cowboy** · 02-27-2026, 01:50 PM

Someone put a 73 steering wheel in my truck so I replaced it with an original that I refurbished and refinished. The horn assembly looked the same with the little copper pin and spring and same parts but when I re-assembled it the horn didnt work.

The first mistake I found was I painted the inside of the wheel hub and its surrounding area. I removed the paint there and tested it with a jumper from the pin and that worked.

Next I found the flex ring and pushes in to contact the hub was not making contact with the center of the hub when pressed. Maybe those rings are different from model years? It has a little plastic surround and mount that I tried sanding the nubs off the back to make it closer and that didnt work. I ended up removing the plastic ring piece and put some silicone around the edges to act as an insulator and when I put it back in that was enough to allow it to flex and make contact.

I hope it will stay insulated and maybe someone here has some experience on how it is supposed to me or if there are different parts?

**Rust_never_sleeps** · 02-27-2026, 02:02 PM

diagram here, but IDK about differences by year
When it works, the contacts just float at the right distance, but if it gets doinked, IDK

https://www.lmctruck.com/steering/st...and-components

02-27-2026, 01:50 PM	#1
IT Cowboy Senior Member Join Date: Jan 2025 Location: Arizona in a van down by the river Posts: 619	I replaced the steering wheel - the horn didn't work Someone put a 73 steering wheel in my truck so I replaced it with an original that I refurbished and refinished. The horn assembly looked the same with the little copper pin and spring and same parts but when I re-assembled it the horn didnt work. The first mistake I found was I painted the inside of the wheel hub and its surrounding area. I removed the paint there and tested it with a jumper from the pin and that worked. Next I found the flex ring and pushes in to contact the hub was not making contact with the center of the hub when pressed. Maybe those rings are different from model years? It has a little plastic surround and mount that I tried sanding the nubs off the back to make it closer and that didnt work. I ended up removing the plastic ring piece and put some silicone around the edges to act as an insulator and when I put it back in that was enough to allow it to flex and make contact. I hope it will stay insulated and maybe someone here has some experience on how it is supposed to me or if there are different parts? __________________ 1972 C10 Custom Deluxe Highlander 402 Freedom isn't safe, it requires you to take responsibility for your own life, your own safety, and your own success. It carries with it the possibility of failure and the understanding that you're working without out a safety net. If you give the state the responsibility for any of these you also give up the freedom that accompanies the responsibility.

02-27-2026, 02:02 PM	#2
Rust_never_sleeps Senior Member Join Date: Jun 2022 Location: San Ramon,CA Posts: 1,072	Re: I replaced the steering wheel - the horn didn't work diagram here, but IDK about differences by year When it works, the contacts just float at the right distance, but if it gets doinked, IDK https://www.lmctruck.com/steering/st...and-components __________________ 1970 C10 Custom longbed 350/350 “Carburetors are forgiving, timing is not” — Thunderhead289



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.