|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
03-10-2026, 03:20 PM
|
#9 |
|
Registered User
Join Date: Nov 2010
Location: calgary alberta
Posts: 9,039
|
Re: Kingpin/spindle bushing question
Some kits have a very thin o ring that goes between the upper part of spindle and the axle to slow water etc from coming in. Grease still gets past. Possibly another one above the bearing too. Important to get shims correct so minimal up and down play. I usually use a fine flat file to get surfaces flat and smooth.
|
|
|
| Bookmarks |
|
|
Threaded Mode