NEED!!! Torque Sequence and values for 350 head - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Locutus · 10-09-2004, 03:42 PM

the search seems to be broken again and I am trying to swap some heads on my truck I am almost to the point of putting the new ones on and I need the torque sequence and torque values for heads on a chevy 350.

Mike

Locutus · 10-09-2004, 03:49 PM

ttt

Locutus · 10-09-2004, 04:27 PM

why did new post start way at the bottom????

Nima · 10-09-2004, 05:08 PM

Based on Haynes manual, the torque for small block intake is 30. Based on edlebrock instruction, the torque for their intakes is 25, then I guess somewhere between 25-30 is ok based on the type of intake. For head, the torque is 65 for small block (based on Haynes). As far as the sequence goes, I have a picture and I'll try to post it, but for now I can just say they start from the middle and gradually goes to the both ends. I hope this helps.

tom hand · 10-09-2004, 07:43 PM

http://members.tripod.com/torquespecs/hi_po_chev.htm

10-09-2004, 03:42 PM	#1
Locutus Registered User Join Date: Jan 2003 Location: Santa Fe, Texas Posts: 249	NEED!!! Torque Sequence and values for 350 head the search seems to be broken again and I am trying to swap some heads on my truck I am almost to the point of putting the new ones on and I need the torque sequence and torque values for heads on a chevy 350. Mike

10-09-2004, 07:43 PM	#5
tom hand CCRider Join Date: Feb 2000 Location: Olive Branch,MS,USA Posts: 2,232	http://members.tripod.com/torquespecs/hi_po_chev.htm __________________ 72 GMC Sierra SWB almost finished---- 84 Softail Olive Branch MS

10-09-2004, 03:49 PM	#2
Locutus Registered User Join Date: Jan 2003 Location: Santa Fe, Texas Posts: 249	ttt

10-09-2004, 04:27 PM	#3
Locutus Registered User Join Date: Jan 2003 Location: Santa Fe, Texas Posts: 249	why did new post start way at the bottom????

10-09-2004, 05:08 PM	#4
Nima Blue 67 Join Date: Apr 2004 Location: Western WA Posts: 1,179	Based on Haynes manual, the torque for small block intake is 30. Based on edlebrock instruction, the torque for their intakes is 25, then I guess somewhere between 25-30 is ok based on the type of intake. For head, the torque is 65 for small block (based on Haynes). As far as the sequence goes, I have a picture and I'll try to post it, but for now I can just say they start from the middle and gradually goes to the both ends. I hope this helps.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.