|
10-10-2004, 09:17 AM
|
#1 |
|
Registered User
Join Date: Aug 2004
Posts: 7
|
intake/cam
the carb on my 72 needs a rebuild -bad. while i'm at it, i figure i'd replace the valve stem seals, and a couple of leaky gaskets. then i got to thinking, why not replace the intake and cam... i'm thinking about the edelbrock performer manifold and cam. anybody else running these? i've got the stock 350. i'm not really looking for a lot of extra power, but i figure a little would be nice.
anybody run this setup, or have any other suggestions? thanks hailey |
|
|
|
10-10-2004, 10:04 AM
|
#2 |
|
The LuvShack Garage
Join Date: Jan 2004
Location: Maple Grove, TN (West Side)
Posts: 30,468
|
NOT RUNNING THAT COMBO, SORRY, BUT WELCOME 2 THE BOARD FROM W. TN
 *FILL IN YOUR SIG UNDER "USER CP" SO WE ALL KNOW WHERE YOUR FROM 
__________________
Owner/Op: "TN Classic Transport Carriers" The Toy: "Square Vette" 72 Hybrid Blazer Toy Barn: "LuvShack" 40 x 60 x 20 Shop Tow Piggy:"Maddy" 88 Silverado 3500 Hauler: "Feathers" 14 Aluma 8218T |
|
|
|
|
10-10-2004, 11:31 AM
|
#3 |
|
Registered User
Join Date: Aug 2004
Posts: 7
|
yeah, i keep meaning to take the time when i get home to fill that out,but i never think about it. i always check this site out when i'm bored at work..
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
