|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
10-21-2004, 11:28 AM
|
#1 |
|
Registered User
Join Date: Jan 2003
Location: Santa Fe, Texas
Posts: 249
|
taper on pistons rings
what is the purpose of the taper on the inside of 1st and 2nd piston rings. On the inside part one corner is squared and one is angled.
Looks Kinda of like this ___ | | |_/ |
|
|
|
10-21-2004, 11:40 AM
|
#2 |
|
Watch out for your cornhole !
 
Join Date: Jun 2003
Location: Azle, Texas
Posts: 14,162
|
It allows the combustion gasses to exert outward pressure on the rings, and therefore on the cylinder walls.
__________________
I'm on the Instagram- @Gearhead_Kevin |
|
|
|
|
10-21-2004, 11:57 AM
|
#3 |
|
Registered User
Join Date: Jan 2003
Location: Santa Fe, Texas
Posts: 249
|
so wich way should they be installed and what happens if they are installed wrong.
|
|
|
|
|
10-21-2004, 12:00 PM
|
#4 |
|
Watch out for your cornhole !
Join Date: Jun 2003
Location: Azle, Texas
Posts: 14,162
|
The little taper should be on top, the square side down.
__________________
I'm on the Instagram- @Gearhead_Kevin |
|
|
|
|
10-21-2004, 12:02 PM
|
#5 |
|
Registered User
Join Date: Jan 2003
Location: Santa Fe, Texas
Posts: 249
|
for both rings?
|
|
|
|
|
10-21-2004, 12:04 PM
|
#6 |
|
Watch out for your cornhole !
Join Date: Jun 2003
Location: Azle, Texas
Posts: 14,162
|
Yes, both. The rings should have included a little piece of paper explaining installation.
__________________
I'm on the Instagram- @Gearhead_Kevin |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
